DIY Emmco style peanut holders
I made this in the last couple days. Thought you guys might like to see...
$32 in steel
Two sets of legs welded up with the support arms in place
One holder complete. I opted to make the center bar bolt in so theoretically it could be broken down if needed.
Second one done
I found these rubber chair caps at Lowes that fit the 1" square tube perfectly
These things are available at Emmco Agility for a lofty $150
each! My pair cost me $56 to make.
RATCHX3 High Jinks vom Neuanfang - Gotchya Day: 1/23/2013 DN, SG, SR, CA
Inspire Spark to Ignition! (Ignite) Gotchya Day: 10/8/2016
C-ATCH Pimg - RATO, UJJ (x2), DJX, HIT, CA, CGC, High in Games, Reserve High in Standard- CPE Nationals 2014